Bertazzoni W90 IND MFE BL Manual download pdf (Page 4)

TYPES OF POWER CORDS

The appliance is equipped with a terminal for the electric connection placed behind, which is accessible removing the

posterior casing (Fig.8)

The cable of alimentation can be :

Operation at 220-240V~ : use a H05BB-F three-wire cable (cable 3x6 mm²)

Operation at 380-415V2N~ : use a H05RR-F o H07RN-F four-wire cable (cable 4x6 mm²)

Operation at 380-415V3N~ : use a H05RR-F o H07RN-F five-wire cable (cable 5x4 mm²)

Fig.9

The power supply cable is suitable for appliance operating on 220-240 V~

APPLIANCE MAINTENANCE

ATTENTION: IMPORTANT WARNINGS

For cookers resting on a base

ATTENTION: If the cooker rests on a base, take the measures necessary to prevent the cooker from sliding along the

support base.

For cookers with glass covers

ATTENTION: Before opening the appliance’s glass cover, carefully remove all liquid residues from the top of it.

ATTENTION: Before closing the appliance’s glass cover, make sure that the work surface has cooled.

For cookers with electric ovens

During use, the appliance becomes hot. Care should be taken to avoid touching heating elements inside the oven.

For cookers with electric ovens

WARNING: Accessible parts may become hot during use. To avoid burns, young children should be kept away.

For the food warmer compartment (or drop leaf in our case)

ATTENTION: The internal parts of the food warmer can become hot during use.

For glass doors

Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they can scratch the

surface, which may result in shattering of the glass.

Do not use steam cleaners to clean the appliance.

REPLACING PARTS

Before performing any maintenance operation, disconnect the appliance from the gas supply and electricity

network.

To replace parts such as knobs, just remove them from the seats without disassembling any part of the cooker.

To replace the electric thermostat, also disassemble the rear cooker guard, loosening the relative screws, to be able to

pull out and reposition the thermostat bulb.

To replace the oven bulb, just unscrew the protection cap that projects out inside the oven. (Fig.10)

WARNING: Ensure the appliance is switched off before replacing the lamp to avoid the possibility of electric

shock.

WARNING: The power cord supplied with the appliance is connected to that appliance with a type Y connection (in

compliance with standards EN 60335-1, EN 60335-2-6 and subsequent amendments) for which it must be replaced by

the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

If the power cord becomes worn or damaged, replace it based on the information reported in ‘appliance electrical

connection’.

WARNING: If the power cord is replaced, the installer shall ensure that the ground cable is longer than the

phase cables and also shall comply with the warnings regarding the electric connection.

To replace the power cable, lift the terminal board’s cover and replace the cable. To access the terminal board in cookers

with a 3x2.5mm² cable, the back panel on the rear of the appliance must be removed.

USE AND MAINTENANCE MANUAL

WARNING: This appliance is not intended for use by persons (including children) with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a person responsible for their safety.

1 2 3 4 5 6 7 8 9 ... 15 16

Comments to this Manuals

No comments

Bertazzoni W90 IND MFE BL Manual Page 4

Comments to this Manuals

Related products and manuals for Cookers Bertazzoni W90 IND MFE BL